Chinese newest dc pulse TIG German supplier HANDY TIG-200Di

1.Welding Process DC TIG
   MMA/TIG/TIG PULSE
2.Mode
   2T(STD)
   4T(HOLD)
  Remote:used for foot pedal or Remote torch.
3.Function Sequence

4.Select welding parameters button
This button is used to select the welding parameters
depending on the welding process and operating mode used.
5.Encoder Control
6.Memory:Memory with capacity of 10 sets parameters.
7.Ammeter/Voltmeter Display
8.Memory Display

1.Gas pre-flow time(TIG)
   Absolute setting range 0.1s to 5.0s (0.1s increments).
2.Ignition current(TIG)
   Percentage of the main current.
   4T(HOLD)
   Setting range 1% to 100%(1% increments).
3.Up-slope time(TIG)
   Setting ranges:0.00s to 20.0s(0.1s increments).
   The up-slope time can be set separately
   for non-latched and latched.
4.Main current(TIG)/pulse cuttent
  I min to max(1 A increments)
  Main cuttent(MMA)
  I min to I max(1 A increments)
5.Pulse time
   Pulse time setting range:0.01s to 9.99s(0.01s increments)
   TIG pulses
   The pulse time applies to
   the main cuttent phase(AMP) for pulses.
   TIG AC Special
   The pulse time applies to the AC phase for AC special.

6.Pulse break time
   Pulse break setting range:0.01s to 9.99s
   (0.01s increments).
   TIG pulses
   The pulse break time applies to the secondary
   current phase(AMP%).
   TIG AC Special
   The pulse time applies to the AC phase for AC special.
7.Secondary current(TIG)/pulse pulse pause current
   Setting range 1% to 100% (1% increments).
   Percentage of the main current.
8.Down-slope time(TIG)
  0.00s to 20.0s (0.1s increments).
  The down-slope time can be set separately
   for non-latched and latched.
9.End-crater current(TIG)
   Setting range 1% to 100%(1% increments).
   Percentage of the main current.
10.Gas post-flow time(TIG)
   Setting ranges:0.1s to 20.0s(0.1s increments).